What should I do if the PVC curtain is not tight enough?

Loose or wrinkled areas in your Pikkuna curtain can usually be corrected with targeted adjustments to the mounting hardware:

Diagnose the Problem Area
First, identify where the looseness occurs. Stand back and observe the curtain from different angles. Common problem areas include corners (diagonal wrinkles), the center of long edges (sagging), or around doors and openings. Understanding the pattern helps you target the right fasteners for adjustment.

Adjust Fastener Tension
For turn buttons: Slightly loosen the two screws holding each button, rotate the button to increase tension on the curtain edge, then re-tighten the screws. Work progressively along the loose edge rather than over-tightening a single point.

For screws: If the curtain is mounted with screws directly through the edge, you may need to reposition some screws. Temporarily remove screws in the loose area, gently pull the curtain taut, and reinstall the screws in slightly different positions (2-3 cm away from the original holes). This redistributes tension more evenly.

For Velcro: Check that the Velcro strips are securely stapled to the frame and that the curtain edge is pressed firmly against the entire length of the Velcro. You may need to add additional staples to the Velcro strip or replace worn sections if the hook-and-loop connection has weakened.

Redistribute Tension Systematically
Don't try to fix everything at once. Make small adjustments to 2-3 fasteners, step back to check the result, then continue if needed. Start with the dominant edge (usually the top), then adjust sides, and finally the bottom. Sometimes loosening an over-tight area allows adjacent areas to settle properly.

Allow Settling Time
Remember that PVC film naturally stretches slightly under tension during the first few weeks after installation. Minor wrinkles often disappear on their own as the material settles. If you notice looseness immediately after installation, wait 3-5 days before making adjustments unless the sagging is severe.

Similar questions

1. Where is Pikkuna installed?

2. What tools are needed for installation?

3. What are the general installation tips?

4. How do turn buttons work?

5. When should I use hooks for mounting?

6. How is Velcro mounting applied?

7. When should I choose screws for installation?

8. What is a weighted bottom edge and when is it used?

9. How do I measure my window opening for Pikkuna, and do I need to account for the width of the edge?

10. Can I install Pikkuna alone?